Page
22
of
23
Cha
p
ter:
10
Ap
p
en
d
ix
22
10.2 INSTALLATION OUTLINE
Power
o
Refer to the electrical tag on the back of the machine OR on the
electrical cabinet (figure 1).
o
Input power goes through the cabinet to the top of the rotary
switch(figure 2).
Air
o
The machine uses compressed air for the dust hood and tool changer.
o
Connect an air supply line to the air pressure regulator located
on the back of the machine(figure 3).
o
The stock fitting is for an 8mm diameter hose.
o
Replace fitting if needed.
o
90-100 psi
Vacuum Pumps
Vacuum pumps will vary between machines.
o
Refer to the vacuum pump electrical tag for correct wiring.
o
Run the appropriate gauge wire from the vacuum pump to the electrical cabinet.
o
There will be a contactor(s) located inside of the electrical
cabinet where the vacuum power is connected(figure 4).
o
Connect the table's vacuum hose to the inlet of the vacuum pump(figure 5).
Dust Collection
o
Set up a dust collector with a 4" hose
connected to the dusthood(figure 6).
o
For a simple solution, insert the provided tubing
into the holder on the right side of the gantry.
o
Secure the dust hose to the tubing, and verify
travel is not restricted.
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 1
