Page
14
of
23
Cha
p
ter:
8
Ma
in
ten
an
ce
a
n
d
Trou
b
le
sh
o
o
tin
g
14
8
MAINTENANCE AND TROUBLESHOOTING
8.1 CLEANING AND LUBRICATING THE MECHANICS
o
The SmartshopM uses linear guide rails, ball screws, and ball bearings. These need to be
lubricated periodically.
o
Scheduled maintenance: Once a week, if the machine is used daily.
o
A visual inspection is always recommended. If the rails are dry to the touch,
then use an oil can and a rag to lubricate them.
o
30WT motor oil or white lithium grease is recommended.
8.2 RESETTING TOOL LOCATIONS
o
Home the machine.
o
This will reset the controller's machine coordinates, relative to the position of the home
switches and flags.
o
Verify the controller is in machine coordinates (workpiece 0)
If not, press
MENU+ZRN/0
to change to machine coordinates.
o
Put an EMPTY tool cone into the spindle using the manual tool release button.
o
Using the handheld controller's jog control, carefully guide the cone into the tool rack.
o
Record the X, Y, and Z position. Verify that these are in machine coordinates.
o
Carefully jog the tool out of the tool rack.
o
Navigate to the ATC stored locations, by following the below steps.
o
MENU
-->
Menu Function User Interface -->
REF/OK
o
Machine Setup -->
REF/OK
o
Scroll down to
ATC setup-->
REF/OK
o
Scroll up to
ATC position -->
REF/OK
o
Press
STOP/CANCEL
to clear the warning.
