Laguna Tools Smartshop II Series, Руководство пользователя

Страница: 26 / 69

26
Fitting the job to the table using the T slots.
You may find it convenient to clamp the job to the
spoil board with the table clamps. This attachment
method can only be used if the outside edges are
not being machined. When using the clamps, place
a piece of packing under the jacking bolt to protect
the bed of the machine.
DO’S AND DON’TS.
1. DO verify water level in the spindle reservoir.
2. DO lubricate all ball screws every 8 hours of run. Use 30w oil or lithium white
grease lubricant or equivalent to lubricate the ball screws and wipe off any
excess to reduce dirt and dust acumination.
3. DO
keep your collets clean. Fine dust builds up, and they get tight.
4. When doing carving work, it is necessary to use a much larger volume of water
for the spindle-cooling reservoir.
5. DO NOT ever under any circumstances reach over the table or obstruct the
movement of the gantry while the machine is powered or running a program.
6. ALWAYS press in the E-STOP button on the control box and turn off main
power prior to changing tooling or working on the spindle. Remember to clear
alarms caused by the E-STOP button on the alarm pages after the E-STOP has
been removed.
7. ALWAYS remove main power prior to working on or servicing the spindles,
water pump or reservoir.
8. The E-STOP button MUST be out before turning on the main power (twist and
it will pop out).
Packing Clamp