Laguna Tools MTST5S-0135, Руководство по эксплуатации

Страница: 31 / 59

5. MAINTENANCE
29
5-3. REPLACING BELT
I. REPLACING THE V-BELTS
1. Disconnect the saw from the power source.
Note: Serious personal injury could occur if you connect your machine to the
power.
2. Make the whole motor unit 4
3. Open the rear door of machine.
4.
Loose the 3 bolts shows on Fig. 5-3.1. to make the motor movable
5. Slowly lift the motor and tighten the bolt for fixing. Then replace the V-belts with
new ones.
Note: make sure the motor pulley and arbor pulley are lined up after replacing.
6. Loosen the bolts as step 4 described, and pivot the motor down to the original
position.
7. Re-tighten the bolts for fixing.
8. Close the rear door
Figure 5-3.1
V-belts
Figure 5-3.1a