Laguna Tools MTST5S-0135, Руководство по эксплуатации

Страница: 22 / 59

3. ASSEMBLY & SETUP
20
3-9 WIRING & TEST RUN
I. Wiring
1. Always check to see if the wires in your circuit are capable of handling the
amperage draw from your machine, as well as any other machines that could be
operating on the same circuit. If you are unsure, consult a qualified electrician.
Note: A fire may occur if your particular electrical configuration does not comply
with local codes. The best way to ensure compliance is to check with your local
licensed electrician.
2. Install the machine on a dedicated circuit to reduce the possibility of overloading
the circuit and tripping the circuit breaker. If the circuit breaker trips and the
circuit are of the correct load capacity, have the circuit inspected by qualified
electrician. Never use a larger circuit breaker than stated below, or you will
increase the risk of fire.
3. The power cord section need to fitted motor power rating by the user, If you are
unsure, consult a qualified electrician.
4. Please CUT OFF power source before open the terminal box for the electrical
connection, the terminal box is fitted at the side next to the machine door, the
connection terminals for the supply cables are marked with L1, L2, L3, N and PE
5. Make sure all electrical circuits are grounded before you connect them to the
machine. DO NOT use the machine if it is not grounded.
6. When the power source is connected to the reverse phase, if the motor wrong
rotary. Please change the incoming wire L2 and L3.