Dake Corporation
1809 Industrial Park Drive
Grand Haven, MI 49417
11
983113
REV112020
SET UP
-
This machine weighs
530lbs
. Transport to desired location before unpacking, please use lifting
jack. Transportation after unpacking, please use heavy duty fiber belt to lift up the machine.
Always keep proper footing and balance while moving this machine.
-
Minimum space required for machine operation below:
INSTALLATION:
Assemble saw pedestal and bolt saw on the pedestal.
1. Tighten all locks before operation.
2. Turn off the power before wiring, and be sure machine is properly grounded. Overload and
circuit breakers are recommended for safety wiring.
3. Check to make sure the main shaft is rotating clockwise, if not reverse the wiring and test
again.
4. Carefully lift the machine to a sturdy stand or work bench. For the best performance, fasten the
machine to a bench or stand. Make sure that the machine in level in all directions.
5. When installing the wheel, raise the table about 8 inches high to facilitate the installation of the
wheel frame and ensue safety.
90’’
90
98”
