Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
976200-2, 976202-2
20
REV112019
7. Use the head feed control knob to adjust the decent of the blade. When the blade
finishes the cut and makes contact with the lower limit switch blade rotation will stop and
the head will return to the upper position.
8. From here the material can be adjusted to make another cut, only the “start cycle button”
needs to be pressed to make another cut.
MAINTENANCE
MAINTENANCE FOR FERROUS HEAD:
•
Gear Box: Maintain safe oil level of oil. Oil should be visible through the sight glass on the
right side of the gear box when machine the is running.
o
Note:
Oil will appear foamy during machine operation. When running at high
speed oil may weep from the filler cap, this is normal and will subside once
machine has expelled out the excess oil in the gear box.
•
Air Oiler: Located on the air regulator. Air must be dry and clean. Use appropriate
measures to ensure this before air enters the machine.
•
Head Feed Cylinder: The oil reservoir is mounted on to the cylinder. The reservoir is
clear, and you can visibly inspect the level. When oil is approximately the depth of 1/4",
oil must be added. To fill the reservoir remove the brass cap on top and add oil into the
reservoir until full and cause the cycle head to bleed.
WARNING LOCK OUT AIR
SUPPLY TO THE MACHINE BEFORE REMOVING THE OIL RESERVOIR PLUG.
•
Chip Drawer: Located behind the front door access door, this drawer pulls out for easy
cleaning.
•
Coolant: This pan is located under the chip drawer. The coolant should be kept clean.
When coolant needs changing, remove the drain plug from the pan.
•
Way Oiler: This reservoir is on the back of the column. This reservoir should be kept
topped off. At the beginning of each shift, this should be pumped twice to maintain good
lubrication for the ways.
•
Gib Blocks: This acts an adjustable guide for the gear box.
•
Vise Gib: Can be adjusted by loosening the lock nuts and turning the set screws equally.
This should be done whenever the vise shifts left or right when clamping.
•
Chip Brush: Replace as needed.
•
Excessive Backlash: This can be reduced by removing the spindle shaft cover plate on
the lower righthand side of the gear box. Using the set screws in plate, loosen the
mounting bolt and tighten the set screws. Tightening these set screws will pull the plate
away from the gear box and allow removal of the plate. With the plate removed tighten
the spindle nut and replace plate in reverse order. Proper backlash will be approximately
1/16” to 1/8” play in the spindle with the blade on the spindle.