Laguna Tools CL1200, Руководство пользователя

Страница: 19 / 45

has 3 tensions and is accessed from under the cross slide at the back of the
machine. [Item 26: exploded view drawing of transversal support] The spring clips
onto hooks. You should always use the strongest spring tension that the template or
master can take without damage.
Copy roughing and finishing
cuts
A facility is provided on the
lathe to enable you to set the
machine for rough and finishing
cuts.
Holder
Follower
Clamp ring
Ratchet screw
Knurled ring
1 . With the follower fully engaged in the holder, bring the clamping ring forward
so that it touches the inside face of the holder, and lock in place.
2 . Adjust the gap between the locking ring and the knurled ring to the depth of
cut that you require for the finishing pass.
3 . Unclamp the clamping ring and move it back so that it touches the knurled
ring, and clamp in position.
4 . Move the follower out so that the locking ring touches the inside of the
housing, and lock in position with the ratchet screw that is located under the
housing.
5. The machine is now set for the roughing cut.
6. After the machine has made the final roughing cut. Release the ratchet
clamping handle and move the follower back, re-clamping in position.
7. Make the final cut.
8. To move the follower to the roughing cut position release the ratchet handle
and move the follower forward, and clamp in position.
To copy-turn
There are several ways to set up for copy-turning and, with experience, you will
decide on the one that suits you. Below is one method that you can use and refine.
1 . Place the template in the “U” clamps provided, push the template so that the
back of the template is flush with the template holder bar and clamp in
position. If you are using a master, clamp between centers and lock in
position.
2. Adjust the saddle copy tool to the biggest radius of the job to be copied. You
can do this by fitting a rotating center into the tailstock and bringing the point
19