Lagler ELF, Руководство по эксплуатации

Страница: 24 / 77

ELF 01.10.2019
English / Englisch
4.3.2 MACHINES WITH THREE-PHASE AC MOTOR
(MAINS VOLTAGE 400 V)
1 Lift the sanding drum off the floor by turning the lowering
lever at the handle upwards (fig. 14)!
2 To switch on the machine turn the switch button at the motor
to position -START- (fig. 19) and release the switch button
after the motor has reached its full speed. The switch button
will then automatically move to position -1- (fig. 20).
If the motor do not start in the switch position -START- (fig. 21, 1) and
the light on the switch box shines (fig. 21, 2), the rotation direction
of the motor is wrong.
To change the rotation direction of the motor using the following
procedure:
1 Disconnect the motor cable from extension cable!
2 Original LÄGLER ® plug with red nut at the cable outlet
(fig. 22, A ):
- Put a screwdriver in the slit of the phase changing switch
in the plug of the motor cable (fig. 23, 1).
- To unlock the phase changing switch press the screwdriver
in the slit and at the same time turn the screwdriver at 180°
(fig. 23, 2).
Original LÄGLER
®
plug with yellow nut at the cable outlet
(fig. 22, B ):
- Put a screwdriver in the slit of the phase changing switch
in the plug of the motor cable (fig. 23, 1).
- To unlock the phase changing switch turn the screwdriver
at 180° against a small resistance (fig. 23, 2).
ATTENTION!
The phase changing switch can only be turned in one
direction! The corresponding direction can be different with
different plugs!
COMMISSIONING
Fig. 21 The motor do not start in switch position
-START- (1) and the light on the switch box
shines (2).
Fig. 23 Change the rotation direction of the motor by
turning the phase changing switch at 180°.
Fig. 22 Original LÄGLER
®
plug with red nut ( A ) or yellow
nut ( B ).
4
23