laerdal SimMan 3G Trauma, Инструкция по применению, Страница: 21 / 64

18
Manikin Setup
System Setup
Setup f
or Sim
ulation
Clinical F
eatur
es
Maintenance
Tr
oubleshooting
Spar
e Par
ts
System Setup
NOTE: When a simulation is running, the ‘Start session’ button
becomes the ‘Pause session’ button. Click this button at any time
during a simulation to pause the session.
RUNNING A SESSION IN AUTO MODE
Launch the Instructor Application, open an Auto Mode patient case
and start the session as described in
Opening an Auto Mode Patient
Case .
MONITOR AND ADJUST PATIENT PARAMETERS
DURING SIMULATION
Throughout the simulation session, the instructor should monitor and
control the patient’s status as exhibited by the Manikin. The severity of
symptoms can be modified using the master patient controls.
Move the appropriate slider to the left to decrease the severity of
the symptoms exhibited by the Manikin, or to the right to increase
severity. Click the appropriate restore button to restore the Manikin
to its original state.
Patient status and simulation progress are displayed in the
following areas:
The Simulation control graph shows the patient status in terms of past,
current and predicted future trends throughout the simulation. The
timer shows the time elapsed since the start of the simulation.
The Instructor’s Patient monitor shows the patient’s current vital signs
and clinical parameters.
The patient status and the <Airway status> window provide at-a-
glance data about the patient’s current status.
MONITOR AND REGISTER LEARNER EVENTS
DURING SIMULATION
As the learner responds to the patient case, the instructor should
register Learner events as they are performed using the <Common
Learner Events> list and/or the <Learner Events menu>.
Some events are registered automatically by the SimMan 3G manikin.
These events are highlighted blue and are marked with a wireless
manikin icon.
Common Learner Events
The <Common Learner Events> window lists the required events/
learning objectives for the selected patient case. To register that a
learner has performed an event, click the relevant item in the list.
A check-mark appears to the left of the item when it has been
registered.
Learner Events Menu
The Learner events menu contains all Learner events. To register that
a learner has performed an event using the Learner events menu:
• Click the relevant body part of the clickable Manikin figure and
select the event from the drop down list.
OR
• For events not specific to a particular anatomical area of the
Manikin, click the <General Events> button and select the event
from the drop down list.
OR
• Search for an event using the Event search field, then select the
event from the drop down list.
Session Log
All learner events added both automatically by the Manikin system
and manually by the instructor are recorded in the Session Log. This
information is available at the end of the simulation session in the
debrief files.
To add a comment on learner performance to the Session Log, click
the <Add Comment> button.
3 INTERACT WITH THE LEARNERS
Open the Voice Conference Application on the Instructor PC. Use
the USB headset to listen in on the learners’ communication with the
manikin, and respond back through the microphone.
On request or when appropriate, provide Radiology, Lab results
or background media files to the learners via the Learner’s Patient
Monitor using the <Transfer Media Files> menu.
END SIMULATION SESSION
When the simulation session is complete, click the <End Session>
button.
SAVE FILES AND DEBRIEF LEARNERS
Save the session log for later debriefing or documentation. Click
<Debrief> to start the Debrief Viewer.