15
Fix the trolley at the desired height (*) using the locking pin [4] and insert the training
handle [12] on the tilting arm [9] at the desired height, fixing it to it using the knurled
locking pin [13] and screwing the plastic ring [11] and the threaded ring [10] to the upper
pin of the handle.
Check again that all the screws are properly tightened, including that of the handling
handle [2].
NOTE(*):
Given the size of the sliding carriage and the geometries of the
various racks on which it is installed, the maximum height at which it
is possible to fix the power arms is:
- 19 hole on a power rack
- hole 18 on a half rack (reduced to 16 in case of HR-APB)
- 17 hole on a foldable rack
ATTENTION:
For half rack installation it is necessary to previously mount a top
connection element such as
HR-APB
or
HR-PBX
.
If you install the power arms on a foldable rack, it can no longer
be closed.
IMPORTANT NOTE:
Repeat the same steps for installing the other arm.
12
13
10
11
2
n 16/18
x2
n 6
x2
n 3
x1
