Labrie Automizer Versa Hand, Руководство оператора, Страница: 76 / 80

70 Operating the A
UTOMIZER
V
ERSA
H
AND
TM
6.
Clean all accumulated dirt under cylinder brackets and inside the side tracks using the hoe and
pressurized water if necessary. Be careful with proximity switches to prevent misalignment.
7.
Perform a visual inspection for leaks or wear in this area.
8.
Rake small pieces of garbage out of the clean-out doors using the hoe.
Figure 4-7 Clean-out door and hoe
9.
Finish cleaning the area with pressurized water.
Daily Chassis Cleaning
Daily chassis cleaning procedure:
1.
Start the engine.
2.
Raise the body until the safety prop is free to tilt under it.
3.
Release the safety prop using the prop handle.
4.
Apply the lockout/tagout procedure (see Locking Out and Taging Out the Vehicle on page 31).
5.
Clean with pressurized water between the body and the frame.
6.
Clean the rear of cab.
7.
Perform a visual inspection for leaks or wear in this area.
8.
When finished, start the engine, lift the body and bring the safety prop back to its vertical
position, then lower the body.
9.
Clean the body all around with water and soap.
10.
Rinse.
Troubleshooting Quick Reference
If an electrical failure occurs and prevents the operator from retracting the arm, the following
procedure can be applied:
1.
Apply the parking brake and put the transmission to neutral.
Clean-out door
Hoe