Labrie Automizer Versa Hand, Руководство оператора, Страница: 71 / 80

Operating the A
UTOMIZER
V
ERSA
H
AND
TM
65
5.
Pull the joystick to raise the grabber inside the hopper. The garbage should then fall down.
Ensure that the roller cart is empty before returning it back to the ground.
6.
Move the joystick forward to lower the grabber.
7.
If needed, extend the arm to place the cart back where it was.
8.
Retract the arm (if extended) and open the grabber when near the vehicle.
Loading Corrective Actions
If the packer does not cycle:
1.
Ensure the hydraulic system is engaged.
2.
Check the emergency red button.
3.
Press the yellow button to ensure the packer is completely retracted.
4.
Check around the packer for any obstruction preventing it from moving freely.
5.
Check fuses and breakers in the console.
6.
Report your findings to maintenance personnel.
Pack on the Go
It may be useful to expedite the collection process and be more efficient. The A
UTOMIZER
V
ERSA
H
AND
TM
gives you the possibility to “pack on the go” or allow the packer to cycle while you drive.
As you are finished loading the hopper, you can activate the multi-cycle switch and press the start
cycle button (green button). This will allow the packer to cycle, even if you are moving the vehicle to
the next pickup. When moving the vehicle, the hydraulic pump will turn at engine RPM, which
depends on truck speed.
The multi-cycle function allows the packer to perform up to eight (8) cycles when pressing the start
cycle button (green button). Standard factory preset of the module is three (3) cycles.
Warning! Do not open the grabber while lifting up the roller cart. If you do the cart will fall down,
causing possible injury and/or equipment damage.
Warning!
Do not move the vehicle if the arm is not fully retracted along the hopper.