Labomed Sigma, Руководство пользователя

Страница: 5 / 20

Fig. 1
1. After the microscope has been used for observation of a specimen
containing bacteria, clean all parts coming in contact with the specimen
to prevent infection.
?
Be sure to remove the specimen before moving this product.
?
In case the specimen is damaged by erroneous operation, it is
important to clean all surfaces that may have come in contact with
the specimen.
2 To avoid potential shock hazards and burns when replacing LED, turn
the microscopes main switch to the OFF position and disconnect the
charger from the wall outlet in advance. Whenever you replace LED
during use or right after use, allow the lamp socket to cool before
touching (Fig. 1)
Applicable LED replacement: LED P/N 2124000-950
3. Install the microscope on a sturdy, level table or bench. Do not place the microscope on a flexible surface, as this
could result in overheating/fire.
4. Always use the charging adapter provided by LABOMED. If the proper charging adapter is not used, product safety
performance cannot be warranted.
5 When installing the microscope, route the charging adapter away from the microscope frame. Should the charging
adapter come in contact with the microscopes base, the charging adapter could short.
6 After operation of microscope has ceased, be sure to disconnect the charging adapter from the connector on the
microscope or from the wall power outlet.
Safety Symbols
Symbol Explanation
Indicates that the surface has a tendency to heat up and should not be touched unless
system has completely cooled down.
Before use, carefully read the instruction manual. Improper use could result in
injury to the user and/or damage to the equipment.
Indicates that the main switch is ON.
Indicates the risk of electric shock.
Indicates that the main switch is OFF.
The following symbols are found on the microscope. For optimal use, it is recommended that users understand
these symbols and always use the equipment as prescribed.
|
!
2
SAFETY INFORMATION
2
Sigma