BA_078_en_10.01 Level transmitter PASCAL Ci4 LEVEL
Page 26/36
When leaving the function, the constant current mode is disabled and the current value
corresponds again to the measured pressure.
6.5.5
"Display" menue
In the "Display" menue, you find all the settings that affect the display on the screen.
Menue entry
Description
Language
Select menue language
Units
Setting units for the different measured and displayed values
Screen mode
Configuration of the screen layout and content (see 6.3.4)
Decimal point
Select setting of decimal point to determine number of decimal
places
Backlight
Switch backlight on/off
Table 14: "Display" menue
6.5.5.1
Submenue "Units"
You can select the unit of every value shown on the display. These settings do not affect
the internal calculations of the device or HART communication.
The shown conversions are only meant for your orientation. The device uses conversion
values with ten decimal places.
Fill height unit
The unit in which the measured fill height should be displayed can be selected from the
following list. This is also the unit for the height offset.
Unit
Description
mm
Millimetre (1 mm = 0.001 m)
cm
Centimetre (1 cm = 10 mm = 0.01 m)
m
Metre (1 m = 100 cm = 1000 mm)
ft
Foot (1ft = 12 in = 30.48 cm)
in
Inch (1 in = 1/12 ft = 25.4 mm)
yd
Yard (1 yd = 3 ft = 36 in = 0.9144 m)
Table 15: Possible fill height units
