BA_078_en_10.01 Level transmitter PASCAL Ci4 LEVEL
Page 14/36
6.3.4
Display layouts
You can configure the layout of the measured value display as well as the displayed infor-
mation individually. There are seven different layouts available:
Designation
Layout
Description
Example
Fill level 4
values
Three secondary values are displayed
under the main value. Vertical bar-
graph
Fill level 2
values
Two values are shown in the same
size, one below the other. Vertical
bargraph
Five values
Under the main value, four additional
values are shown. Horizontal bargraph
Four values
Under the main value, three additional
values are shown. One of these can
use the entire display width. Horizontal
bargraph
Three
val-
ues
Under the main value, two additional
values are shown. Both of them can
use the entire display width. Horizontal
bargraph
Two values
Two values are shown in the same
size, one below the other. Horizontal
bargraph
Large
dis-
play
The main value is shown at the maxi-
mum size (best readability from a dis-
tance). One additional value can also
be shown. Horizontal bargraph
Table 4: Display layouts
The horizontal bargraph is always used in menue mode regardless of the selected layout.
You can define what information shall be shown in the layout’s placeholders. You can se-
lect the 1st value (main value) from the following data:
Fill height in the selected unit
Fill volume in the selected unit
Fill weight in the selected unit
Pressure in the selected unit
Current in percent
Current in mA
