![background image](http://html1.mh-extra.com/html/labelmate/pm-300-ls/pm-300-ls_user-manual_3175891004.webp)
Labelmate - The World’s Leading Manufacturer of Label Dispensers, Rewinders, Unwinders, Slitters & Counting Solutions
SET-UP
• Plug the power supply output cable to the power jack on the rear panel of the PM-300. Plug the power supply into a
suitable AC power Mains Outlet. Place the power switch on the rear of the PM-300 to the ON position.
• The optional Counter (if included) is pre-programmed as a preset count-up Counter. To use the preset function, input
the desired number of labels with the push buttons on the Counter. If you do not use preset, set the value to zero.
• When the preset number of labels is reached, the PM-300 will stop. Pressing the RESET on the Counter will reset the
count to zero so the PM-300 can be started again. A duplicate reset switch is located on the left side of the unit.
FRONT CONTROL PANEL
START
STOP
POWER
ERROR/STOP
INK LOW
GAP
SPEED
•
POWER (GREEN
): Indicates power is applied to the unit. The ON-
OFF Power Switch is on the rear of the Unit.
•
ERROR/STOP (RED)
: Indicates that either the unit is in STOP
mode or one of these three Error Conditions has occurred:
1.
The unit is out of paper
2.
The count has reached the Pre-Set Value
3.
There is a Print-Head Error condition. E.g. No more ink. (condition
valid only if the Print Head supplies this signal)
•
INK LOW (RED)
: Indicates that the Print Head has sent an Ink-Low
Signal
•
GAP (YELLOW)
: Flashes when unit is running, indicating proper
detection of the gap between successive labels.
• START BUTTON (WHITE):
Start printing, if no Error Condition is present.
• STOP BUTTON (RED):
Holding down this button will stop the machine when the next gap passes in front of the photo-
cell.
• SPEED CONTROL:
Varies the speed from zero to maximum.
Getting started
LEFT SIDE CONTROL PANEL
TEST
ADJUST
RESET
TEST
: Green LED, GAP
RESET
(
Only if optional counter is fitted)
: The toggle switch is a momentary
closing switch that has the same function as the reset button on the counter.
ADJUST
: Potentiometer for Photocell (see below)
IMPORTANT: CALIBRATION OF THE PHOTOCELL
The label detector photocell has been adjusted at the factory and requires no adjustment for a large variety of labels.
However, some specific labels (very transparent or relatively opaque backing paper) might require adjustment of the
photocell.
Load a roll of labels on the machine and position the backing paper in front of the photocell. Make sure that the labels
are tensioned when doing the calibration. The green LED should light on. If not, rotate the potentiometer till LED goes on
“green”. Now put a label in front of the photocell, the LED should turn off.
Содержание PM-300-LS
Страница 45: ...Labelmate com HEBREW Labelmate Labelmate ANSI Labelmate www labelmate com EX...
Страница 71: ...Labelmate com SERBIAN...
Страница 73: ...Labelmate com 300 1 4 5 1 230 0 15 40 80 15 1 12 15 15 0...
Страница 86: ...32 2 375 69 60 brussels labelmate com Chauss e de Ruisbroek 290 1620 Drogenbos Belgium www labelmate com...