Labconco XPert 38872 Series, Руководство пользователя

Страница: 14 / 68

Chapter 3: Getting Started
Product Service 1-800-522-7658
10
Stand and Cabinet Installation
1. The top surface of a base stand can be adjusted
from 27.5 to 34.50 inches (698mm to 876mm),
in 1 inch (25mm) increments. Choose your
optimum working height from the floor to the
work surface.
2. Slide (4) leg extensions into base stand corner
posts and attach with larger diameter 5/16"-18
x 2-1/4 inch (57mm) long bolt, flatwasher,
lockwasher and acorn nut. Ensure that the
same height hole is selected for each leg.
Tighten the leg bolts securely.
3. Move the base stand into its final location. For
stands with leveling feet, use a carpenter level
to adjust in both planes as shown in figure
below.
4. XPert Nano Enclosures have an integral
stainless steel work surface with mounting
holes on the underside. Hardware is provided
with the stand. Set the enclosure and work
surface onto the stand with the front edge of
the work surface flush (even) with the front
edge of the stand. Loosely attach each of the
four mounting locations of the work surface
with the smaller diameter 1/4"-20 x 2.5 inch
(63mm) long hex head bolts, nuts and washers.
Tighten when all four bolts have been started.
To change the height of the base stand,
remove these four nuts, washers and bolts
Install four bolts and flat
washers into base of cabinet