Chapter 4: Using Your Washer
Product Service 1-800-522-7658
31
Interrupting a Wash Cycle
To temporarily pause a wash cycle, simply unlatch the washer door. After the
door is unlatched, wait 4 to 5 seconds before opening the door to prevent water
from splashing out of the washer.
To resume the wash cycle, close and re-latch the washer door. The washer will
pause to equalize temperatures and then the cycle will resume the interrupted
segment.
The wash cycle can be terminated at any time by pressing the Start/Cancel button.
Alarms
Throughout a wash cycle there are several abnormal events that could occur. The
washer is programmed to monitor these occurrences and provide an alarm to alert
the operator. Information is shown on the display to identify the alarm situation.
The following messages may be displayed. Certain alarm situations are signaled
with an audible sound which self cancels after 1 minute.
HOT GLASS
This displays at the end of a cycle if the temperature inside the washer is
over 122°F (50°C). The alarm cancels when the temperature cools.
PLEASE WAIT
This displays if the door is opened and then closed during a wash or rinse
segment of a cycle. The display will also show the time remaining until
the operation of the washer will resume where it was interrupted.
WATER LOW
This displays if a water fill is inadequate. The washer will cancel the
cycle and drain water that is in the washer. The alarm is canceled by
opening the door. See
Chapter 7: Troubleshooting
– Washer will not fill.
