Labconco FreeZone 794801 Series, Руководство пользователя

Страница: 14 / 52

Chapter 3: Getting Started
Product Service 1-800-522-7658 10
Original instructions
3. Loosen both clamps on the lower rubber coupling and slide the coupling
upward so the bottom edge of the coupling is above the lower edge of the
stainless steel tube. Snug both clamps on the coupling to hold them in
place.
4. Lift the Stoppering Tray Dryer into place on your Freeze Dryer while
centering the vacuum coupling over the vacuum connection port. Align
the four mounting holes in the Stoppering Tray Dryer support stand with
the four holes in the top of the Freeze Dryer. Install the four bolts, nuts,
and washers provided.
NOTE: Do not lift the Stoppering Tray Dryer by the acrylic door.
5. Loosen the clamps and slide the lower rubber coupling down over the
vacuum connection port. Orient the clamps to gain access and tighten the
clamps to provide a leak-free connection.
Electrical Connection
Plug the power cord into the receptacle on the back of the Stoppering Tray Dryer
and plug the other end into a suitable power receptacle.
DO NOT ATTEMPT TO PLUG THE STOPPERING TRAY
DRYER INTO THE FREEZONE FREEZE DRYER.
CAUTION: When the appropriate power cord is plugged into
the power receptacle on the rear panel of the Stoppering Tray
Dryer, the clamp on the receptacle should be tightened to
prevent the cord from accidentally being switched with the
Freeze Dryer cord located underneath the Tray Dryer. (The
Freeze Dryer may require different mains A.C. voltage and
switching these power cords may cause damage).
Freeze dryer
Stainless steel tube
Stoppering tray dryer
1/4-20 x 3/4 hex head
screw (4) places
1/4" flat washer
(4) places
1/4" flat washer
(4) places
1/4-20 nut w/ integral
lockwasher (4) places
Do not remove this panel
Rubber coupling
Plastic plug
(4) places
Remove flat gasket
if in place on vacuum
connection port
Clamp
!
