Labconco FreeZone 6, Руководство пользователя

Страница: 22 / 77

16
Product Service: Domestic 1-800-522-7658, International 816-333-8811
Chapter 3: Getting Started
Setting Up Your Freeze
Dryer
After you verify receipt of the proper components,
move your Freeze Dryer to the location where you want
to install it. Then, follow the steps listed below.
Component Orientation
The refrigeration system in the Freeze Dryer exhausts
air through the rear of the cabinet. A minimum of 3"
should be allowed between the back of the Freeze
Dryer and the adjacent wall surface. Restriction of the
airflow through the cabinet during operation could
adversely affect performance.
Vacuum Pump Connection
A vacuum pump with a rated capacity of 150 liters per
minute is required to operate your Freeze Dry System
properly. The unit is equipped with a 3/4" ID, heavy
wall, vacuum hose for connecting the vacuum pump to
the collector chamber on the unit.
Remove the front or rear panel from the freeze dry unit
and place the vacuum pump on the floor of the cabinet
next to the refrigeration module. Connect the vacuum
pump power cord to the receptacle on the junction box
labeled “vacuum pump”. If the vacuum pump has an
off/on switch, turn the switch on. The vacuum pump
will be controlled by the Freeze Dryer. Connect the
vacuum pump inlet port to the collector chamber with
the vacuum hose and clamp provided. If necessary, cut
the hose to proper length to allow for gentle bends
without kinks.