Chapter 3: Getting Started
Product Service 1-800-522-7658
8
If you did not receive one or more of the components listed for your washer, or if
any of the components are damaged, contact Labconco Corporation immediately
for further instructions.
Removing the Shipping Skid
After you verify the washer components, move your washer to the location where
you want to install it. Then, follow the steps listed below to remove the shipping
skid from your washer.
To remove the shipping skid:
1.
Remove accessories and loose items from inside the washer. Cut tie wraps
and remove racks.
2.
Gently place the washer on its back, positioning the washer on the shipping
carton or other cushioning material.
3.
Remove the four screws fastening the skid to the washer.
4.
Retain the shipping skid until you test the various features of the washer.
Washer Installation
After you remove the skid from your washer, you must install leveling feet on the
bottom of the washer.
Installing the Leveling Feet
1.
Locate the holes on the bottom of the washer where the four skid-fastening
screws were previously attached.
2.
Thread the four leveling feet into the holes.
3.
Carefully move the washer into an upright position. Be careful to distribute
the weight evenly on the leveling feet when setting the washer upright.
4.
Reinstall racks.
