Labconco 6520000, Руководство пользователя

Страница: 22 / 32

Chapter 5: Servicing the RapidStill II
Product Service 1-800-522-7658 19
Heating Element Replacement
(1) Unplug the RapidStill II.
(2)
Remove the boiler as described previously.
(3) Remove the perforated screen surrounding the heating element by
removing the three screws that secure it.
(4) Disconnect the two heating element wires from the wiring harness by
pulling the electrical connectors straight apart. Remove the ground
wire from the bottom of the heater cup by pulling the wire straight
down.
(5) Remove the four nuts and lockwashers that secure the heating element
cup and its platform to the frame of the RapidStill II.
(6) Pull the heating element cup and its platform straight away from the
frame.
(7) Remove the heating element cup from its platform by removing the
three screws on the underside of the cup.
(8) Remove the heating element from the cup by removing the two heating
element bulkhead nuts located on the bottom of the cup. Pull the
element and its wires straight out of the cup.
(9) Install the new element by reversing the above steps.
Condenser Extension Replacement
(1) Rotate the safety screen assembly up until it is fully open.
(2)
Loosen the knurled nut that secures the condenser extension to the
distribution head. Remove the plastic clamp that connects the
extension to the condenser.
(3) While supporting the condenser, use a Phillips screwdriver to remove
the screws that secure the condenser bracket straps to the condenser
bracket.
(4) Rotating the condenser out of the way, pull the extension straight out of
the distribution head.