Lab-Volt Tech-Design eSeries, Руководство пользователя

Страница: 38 / 53

Activity Guide
30 Tech-Design by Lab-Volt
Temperature Control Controls & Sensors
Temperature Control
Open the ROBO Pro software. Follow the directions below to complete the activity.
In this activity, you will construct the fischertechnik model, called Temperature Control. Refer to the
illustration on the following pages as you construct this model.
Start building with the black base unit and add the blocks to it as shown in the illustration. The 1.
number in front of the “x” is the quantity of that item used in this step. The red horseshoe shaped
pieces are for holding the wires in place. The controls and sensors used in the fischertechnik
system have wires with small plugs on the ends to connect to the interface.
Assemble the motor, fan blade, and fan guard into their locations as shown in the illustration.
2.
Assemble the lens tip lamp and the thermal sensor as shown in the illustration. 3.
Insert the interface onto the four corner mounting blocks and connect the wiring to the interface unit 4.
as shown in the circuit diagram illustration. Next to each red and green wire are the approximate
lengths in metric and standard units. Pay attention to the color location of each red and green
connector on the device and on the interface.
Make sure you’ve made all the plug connections on the interface (including power). Place the wires
5.
in the red clips, as described, before running them in the most direct route to the interface. Feel free
to route the wires in a more convenient direction if your wires have become too short because of
repairs. Just make sure they are making the same electrical connection needed.
NOTE : You will use this model in the next activity. Keep it in a safe place.