La Spaziale S11 BRIO, Инструкция по эксплуатации и техническому обслуживанию, Страница: 10 / 60

10 MUM S11BRIO REV0
1
PREPARATION FOR USER INSTALLATION
Place the appliance on a flat surface to ensure secure support. Verify this important requirement as
the manufacturer shall not be held responsible e for damages caused by appliance instability. When fitting
for installation, make sure there is an opening on the supporting surface to enable connection to the water and electrical mains in the
compartment below,
where the softener must be positioned, if deemed necessary by the installer.
A 10 x 10 cm opening is sufficient in the area (a) indicated in fig. 1.
Minimum compartment measurements are:
- height cm. 60
- width cm. 40
- depth cm. 40
Key:
1) General switch plug
2) Water shut-off valve
x) min. 20 cm.
y) min. 40 cm.
z)* min. 10 cm.
* Distance between rear part of the appliance and the wall.
• The plug must be positioned so that it is
easily accessible.
• A water shut-off valve must be installed between the water mains and the water supply tube of the appliance
so that water can be
shut off if required (fig. 1).
• Water mains connection must be between 1 and 5 bars.
Contact the manufacturer if this last requirement is lacking.
Please Note!
The appliance is supplied without water in the boiler, to avoid irreparable damage from exposure to low temperatures
. Only cold water intended for human consumption must be used in the appliance.