(P/N) 731.018 Rev H 12/14 • © copyright 2008-2014
Kaba Mas LLC
page 7 of 11
Figure 9
SEND SETTINGS TO THE LOCK
A LA GARD Interface adapter and programming cable is required to program the lock.
1. Connect Entry Device to the lock by plugging the cable into the lock port marked ENT.
2. Connect power to the lock through the Entry Device (9-volt battery) or by connecting a LA GARD battery box or AC Power Adapter
to the lock port marked BAT.
3. Plug the Interface Adapter with the appropriate programming cable into PC.
4. Plug the programming cable into the audit/programming port of the Entry Device (Figure 10).
5. Click on the
Transmit button in the software (Figure 11).
6. Press the
0 key on the keypad to begin transmitting the configurations to the lock. (Figures 12, 13, &14).
• If the COM port has been incorrectly set, return to the setup window (Figure 2), and reset the COM port to the correct one.
• If you do not know which COM port to use, check the computer’s device manager.
7. Disconnect the programming cable from the Entry Device.
8. Repeat steps 3 - 7 for each lock to be programmed with this configuration.
NOTE: If you receive a transmission error, check connections and COM port setting. Then resend the configuration settings to
the lock.
