(P/N) 731.018 Rev H 12/14 • © copyright 2008-2014
Kaba Mas LLC
page 10 of 11
8. Test unit operation several times before closing the door.
NOTE: If default combinations are used, it is recommended that they be changed. New combination will not be accepted if it varies
from the current combination by only one digit (+/-). (Example A: 1-1-1-1-1-1 to 1-1-1-1-1-3 is incorrect. Example B: 1-1-1-1-1-
1 to 1-1-1-1-3-2 is correct.) When selecting a combination, do not use a birthday or other predictable information that could give
correlation between the user and the combination.
PROGRAM THE LOCK USING THE KEYPAD ONLY
EXIT FACTORY STATE
CAUTION: Always perform this operation with the door open!
1. Press and hold the
0 key until lock double signals.
2. Enter the default Manager combination, 5-5-5-5-5-5.
The lock will open. Lock is now in Manual Setup.
SET COMBINATION LENGTH
1. Enter the default Manager combination (5-5-5-5-5-5) and
hold down last digit of combination until lock double signals twice
release and the LED stays on.
2.
PRESS 8.
3. Enter combination length (6, 7, 8, or 9).
4. Press
0.
5. Enter combination length a second time and press
0 to confirm.
Example setting a combination length to seven digits:
Enter 5-5-5-5-5-5 (hold down the last number) 8 - 7-0-7-0.
6. To test, enter default Manager combination 5-5-5-5-5-5-5 (all fives to length of combination). Lock will signal twice and lock
will open.
NOTE: If combination length is changed after Users are enrolled, all Users will be deleted and must be re-enrolled.
CAUTION: To maintain the VdS Class 2 and EN 1300 Class B certification when the Silent alarm feature is used, a combination
length of 7 digits or longer must be selected.
CONFIGURE LOCK MODES (ONLY IN SETUP MODE, MANAGER COMBINATION NOT CHANGED)
1. Enter default Manager combination (all fives to length of combination) and hold down last digit of combination until lock double
signals twice and the LED stays on.
2.
PRESS 8.
3. Enter
0 (this maintains current combination length value).
4. Enter desired Lock Mode configuration from the chart below.
5. Enter
0 and re-enter the desired Lock Mode configuration to confirm.
NOTE: Dual Mode cannot be selected if at least one additional User has not been enrolled. User 9 must be enrolled to use the Time
Delay Override function.
MODE
TIME DELAY OVERRIDE
DUAL MODE
SILENT ALARM
0
1
P
2
P
3
P
P
4
P
5
P
P
6
P
P
7
P
P
P
