LOHAS T1
ASSEMBLY INSTRUCTION
1. Place the left upper housing (13) into position.
(FIG.5)
2. Place the lower housing (14) into position
ensuring that:
a) That the interlocking pins (B of FIG.6) slide
into position.
b) And also the front plastic pin on the lower
housing (A of FIG.6) fit into the handlebar
socket hole.
3. Using the screw (15) tighten the lower housing
first and then followed by the screw (18) for the
upper housing. (FIG.5)
4. Repeat steps 1, 2 & 3 on the right side using
parts upper housing (16) and lower (17).
1. Place book holder bracket (22) onto the rear of the console (2 holes on the
bracket). Use 4 screws (23) to secure.
2. Slide book holder (21) down onto the brackets (22). Use 4 screws (24) to secure.
(3 holes on the bracket)
1. Remove the screw (5) , and nut (6) from
both left and right sides of base frame.
2. Raise the support post (3) , (4).
(FIG.1)
3. Refit the screw (5) , and nut (6) to both the
left and right sides of base frame and
tighten. (FIG.2)
1. Connect the power wires (7A) , (7B).
Note:Insert excess wiring into right side of console tube.
2. Place console (9) and handlebars (8) onto the support post, Tighten the screws (10)
to both the left and right sides.
Warning:
Make sure all the cables/wires are not pinched when the screws are tightened.
3. Connect the bottle holder (11) on the bottle rack of console. (FIG.3)
1. If necessary, rotate console tube to get correct position for console racks on
handlebars.
2. Tighten 4 screws (20) and washers (19) under both sides of console tube. (FIG.4)
STEP 1:
Support post assembly
STEP 2: Handlebar assembly
STEP 4: Support post housing assembly
STEP 3: Console rack assembly
STEP 5: Book holder assembly (Optional function)
FIG.2
4
6
5
5
6
3
5
FIG.1
3
FIG.3
10
10
9
11
12
8
7A
7B
FIG.5
16
18
13
15
17
18
14 15
FIG.4
20
19
20
19
FIG.6
A
B
14
Back of console
FIG.7
21
24
22
23
3
