background image

 

37 

If the Weather Station is moved to another location significantly higher or lower than its initial 
standing point (for example from the ground floor to the upper floors of a house), remove the 
batteries and re-insert them after about 30 seconds. By doing this, the Weather Station will 
not mistake the new location as being a possible change in air-pressure when really it is due 
to the slight change of altitude. Again, disregard weather forecasts for the next 48-60 hours 
as this will allow time for operation at a constant altitude. 

 

THE WEATHER TENDENCY INDICATOR 

Working together with the weather icons are the weather tendency indicators (the upward 
and downward arrow located near the Weather girl). When the indicator points upwards, it 
means that the air-pressure is increasing and the weather is expected to improve, but when 
indicator points downwards, the air-pressure is dropping and the weather is expected to 
become worse. 

 

Therefore, user may see how the weather has changed and is expected to change. For 
example, if the indicator is pointing downwards together with cloudy icons, it means that the 
last noticeable change in the weather was when it was sunny (the sunny icon only). 
Therefore, the next change in the weather will be the cloudy icons since the indicator is 
pointing downwards. 

 

Note: 

Once the weather tendency indicator has registered a change in air pressure, it will 

remain permanently visualized on the LCD. 
 
 

 

38 

DISPLAY OF TEMPERATURE AND HUMIDITY READINGS: 

 

INDOOR TEMPERATURE 

The indoor temperature and humidity are measured automatically and displayed on the 
fourth section of the LCD. 
 
 
 
 
 

 

 
 

OUTDOOR TEMPERATURE: 

The last LCD section shows the outdoor temperature, a reception symbol and a channel 
number under the temperature will also show if more than one transmitter has been used. 
 
 
 
 
 
 
 
 
 

Indoor 
Temperature

in °F

Indoor Relative 

Humidity %

Maximum icon

 

Outdoor temperature 
in 

F

 

Outdoor 

Reception

Symbol

Transmitter Identification No. (only shown 
when more than one transmitter is used)

 

 

39 

DISPLAY OF INDOOR MAXIMUM AND MINIMUM RECORDS: 

1. 

In normal display mode, press the MIN/ MAX button three times. The maximum indoor 
temperature and humidity will be shown. Also the date and time of recording this 
temperature will be displayed. 

2. 

Press the MIN/ MAX button once more to display the minimum indoor temperature 
and humidity. Also the date and time of recording this temperature will be displayed. 

 

RESETTING THE INDOOR MAXIMUM/ MINIMUM RECORDS 

1. 

In normal display mode, press the MIN/ MAX button to advance to the MIN/ MAX 
display. 

2. 

Press and hold the SET key for about 3 seconds; this will reset all indoor minimum 
and maximum data recorded to the current time, date, temperature and humidity. The 
max/ min temperature of the currently selected outdoor channel will also be reset at 
the same time. 

 

DISPLAY OF OUTDOOR MAXIMUM AND MINIMUM RECORDS: 

1. 

In normal display mode, press the CH/ + button to select the desired channel. The 
channel ID will be displayed above the outdoor temperature reading. 

2. 

Press the MIN/MAX button, the max temperature of the selected channel will be 
displayed. Also the date and time of recording this temperature will be displayed. 

3. 

Press the MIN/MAX button once more, the min temperature of the selected channel 
will be shown. Press the ALM button to go back to the normal display mode. 

 
 

 

40 

RESETTING THE OUTDOOR MAXIMUM/ MINIMUM RECORDS 

Note:

 It is required to reset the outdoor MAX/MIN temperature records of different channels 

separately. 

 

1. 

In normal display mode, press the CH/ + button to select a channel (1, 2 or 3). The 
channel ID will be displayed above the outdoor temperature reading. 

 

Note: 

The transmitter number will only be displayed if more than one transmitter is applied. 

 

2. 

Press the MIN/ MAX button once. The max icon will be displayed. 

3. 

Press and hold the SET button for about 3 seconds; this will reset all outdoor 
minimum and maximum temperature recorded to the current time, date and 
temperature. 

 

Note:

 The max/ min temperature records of the indoor channel will also be reset at the same 

time. 
 

SUNRISE/ SUNSET/ SUN DURATION TIME: 

 

 
 
 
 
 
 

Short form of City 
name (For example, 
JFK - New York)

 

Sunrise/ sunset 

display

Sunrise time/ Sunset 
time/ Sun duration time

 

Содержание WS-9711U-IT














Отзывы: