14
TOGGLING AND RESETTING THE OUTDOOR RECORDINGS:
1.
To toggle between the outdoor current, MIN/MAX temperature and humidity data and the times (for
temperature data only) that were recorded press the MIN/OUT key:
Once to show the MAX outdoor temperature and humidity data with the recorded time and date.
Twice to show the MIN outdoor temperature and humidity data with the recorded time and date.
Three times to return to the current displayed values.
2.
To toggle between transmitters, press the CH/+ key:
Once to show transmitter 2
Twice to show transmitter 3
Three times to return to transmitter 1
Note: The transmitter number will only be displayed if there is more than one transmitter being
used
.
3.
To reset the MIN/MAX outdoor temperature, and the time at which they were recorded, press and
hold the MIN/OUT key for about 4 seconds. This will reset all MIN/MAX data recorded to the
displayed values for that particular transmitter.
TO EXIT THE MANUAL SETTING MODE
To exit the manual setting mode anytime during the manual setting modes, press the SNOOZE key anytime
or wait for automatic timeout. The mode will return to normal time display.
E.L. BACK-LIGHT
The back-light is automatically switched ON when any keys are pressed. The back-light will be switched on
for approximately 10 seconds before automatically switching OFF. However, if the SNOOZE key is pressed
and held down, then back-light will remain ON constantly until the key is released.
ABOUT THE OUTDOOR REMOTE TEMPERATURE/HUMIDITY SENSOR
The range of the remote temperature/humidity sensor may be affected by the temperature. At cold
temperatures the transmitting distance may be decreased. Please bear this in mind when positioning the
sensor. The battery life may be reduced as well at cold temperatures.
CHECKING FOR 433MHz RECEPTION
If the outdoor temperature and humidity data is not being received within three minutes after setting up
(the display shows “- -. - °F” and “- -%” on the outdoor section of the weather projection station after 3
attempts during normal operation), please check the following items:
1.
The distance of the weather projection station or remote temperature/humidity sensor should be at
least 6 feet (2 meters) away from any interfering sources such as computer monitors or TV sets.
2.
Avoid placing the remote temperature/humidity sensor onto or in the immediate proximity of metal
window frames.
3.
Using other electrical products such as headphones or speakers operating on the 433MHz-signal
frequency may prevent correct signal transmission or reception. Neighbors using electrical devices
operating on the 433MHz-signal frequency can also cause interference.
Outdoor
temperature
in °F/ °C
Outdoor relative
humidity in RH%
Transmitter
identification number
(only if there is more
than one transmitter)
Outdoor reception
indicator
