21
displayed on the Temperature Station. If this does not happen after 2 minutes, the batteries will need
to be removed from all the units and reset from step 1.
7.
Insert the batteries in the third transmitter as soon as the "channel 2" icon and outdoor data are
displayed on the Temperature Station. Then within 2 minutes, the channel 3 outdoor data from the
third transmitter will be displayed and the channel icon will shift back to "1" once the third transmitter
is successfully received. If this is not happen, user shall restart the setting up from step 1.
Note :
User shall insert the batteries into the third transmitter within 45 seconds after the
Temperature Station displays the information of the first transmitter. Or immediately after reception of
the second transmitter is finished.
8.
In order to ensure sufficient 868 MHz transmission however, the distance between the Weather
Station and the transmitter should not be more than 100 meters (see notes on “
Positioning” and
“868 MHz Reception
”).
IMPORTANT:
Transmission problems will arise if the setting for additional sensors is not followed as described above.
Should transmission problems occur, it is necessary to remove the batteries from all units and start again
the set-up from step 1.
HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE STATION
The Temperature Station uses 2 x AA, IEC LR6, 1.5V batteries. If the batteries need
to be replaced, the low battery symbol will appear on the LCD.
To install and replace the batteries, please follow the steps below:
1.
Insert finger or other solid object in the space at the bottom center of the
battery compartment and lift up to remove the cover.
2.
Insert batteries observing the correct polarity (see marking).
