Note:
If the Projection clock is powered through the adapter, the projection will be constantly ON at the highest
brightness level unless the brightness level is manually changed to a lower brightness level afterwards. And the
brightness of the projection can be change accordingly to enhance the clarity of the projected time by pressing
the key.
If the Projection clock is battery operated, the projection will be ON at the highest brightness level only when the
SNOOZE key is pressed. The intensity of the brightness level of the projection cannot be changed. If the
SNOOZE is released, the projection will be turned OFF.
Important!
If the DCF-77 signal is not being received, no keys functions can be used. In that case, either
wait for the next reception of the DCF signal or proceed to manual time setting after reset of the
clock for activation of the keys function.
BATTERIES POWERED WITH THE USE OF AC/DC ADAPTER
If the Projection clock is first powered by batteries and the power adapter is subsequently used for extended
period of time, the main power source of the Projection clock will switch to AC/DC power. The batteries will then
act as a backup power source in case of power failure.
TO RESET THE PROJECTION CLOCK
To reset the Projection clock to the factory default setting or in case of a malfunction, please remove all
batteries from the unit and unplug the AC/DC adapter from any power source. Wait at least for
3 minutes
before powering up the Projection clock again.
FUNCTION KEYS:
The radio-controlled Projection clock uses the following keys:
SNOOZE
: Activate or deactivate snooze function
Alarm snooze function
: Activate the projection brightness at the highest level
: Exit the setting modes
:
Back-light-On
AL/HR :
Enter alarm setting mode
:
Activate or deactivate alarm
:
Stop alarm and snooze function
: Set the hours and
day
:
Back-light-On
MODE/MIN
:
Enter manual time setting mode
: Toggle between indoor temperature, seconds, alarm time, and date display
: Enter time zone setting mode
: Set the minutes, weekday
and month
: Stop alarm and snooze function
:
Back-light-On
: Set the brightness level of the projection (in A/C power mode)
(4 levels: High, Medium, Low, OFF)
:
Back-light
On
(BRIGHTNESS
key)
: Project the image direction (can display 4 different orientations)
:
Back-light
On
(DIRECTION
key)
