La Crosse Technology, Ltd.
Page 4
Note
: When the backlight is off, press any button to activate the backlight for 10 seconds, and
then it will turn off again.
Battery power
:
Press and release the SNOOZE/LIGHT HI-LO-OFF button and the backlight will show for 10
seconds, when operating on batteries only.
IMPORTANT:
When operating on a/c power,
the backlight, projection and USB charging
port
will turn off while the Projection Alarm Clock searches for the WWVB signal, to avoid
interference. The backlight and projection will return after the 2-10 minute search (which occurs
during the late night or early morning hours). Then the USB charging port will resume working.
Time is off by hours
Check to see if the WWVB Tower icon appears on the Projection Alarm Clock. If not, the
Projection Alarm Clock has not received a WWVB time signal in the past 24-hours.
Reposition the Projection Alarm Clock with the front or back facing Colorado.
Check that the Time Zone selected correctly reflects your location. Adjust the time zone in
Check that the DST indicator is correct for your location (most areas observe DST so this
should be ON). Adjust the DST indicator in the Program Menu.
Large buildings, metal roofed buildings and buildings or rooms full of electrical and/or radio
equipment make it difficult to receive the WWVB time signal.
Projection Adjustments
Battery Power:
Press and release the SNOOZE/LIGHT button to show the projection for 10
seconds.
Note: Projection will not display constantly when operating on battery power.
A/C Power:
Projection is displayed constantly unless turned off.
OFF: Hold the +/PROJ ON/OFF button to turn the projection OFF while operating on a/c
power.
ON: Hold the +/PROJ ON/OFF button to turn the projection ON while operating on a/c
power.
Rotate Projection:
Press and release the PROJECTION button to rotate projection image
90 degrees. Press and release the PROJECTION button again to rotate another 90
degrees.
Change Projection Mode:
Hold, then release the PROJECTION button to switch projection
modes. Watch the projection image to view the changes.
•
Time and Indoor Temperature:
alternate every 5 seconds (default)
•
Time:
Hold and release PROJECTION button
•
Indoor Temperature:
Hold and release PROJECTION button again
Projection not working
When operating on a/c power and no constant projection shows, yet it works when you press
the SNOOZE button
please check
:
