LA CASTELLAMONTE RNO 200, Инструкция по эксплуатации

Страница: 17 / 33

17
INSTALLATION
VENT SPECIFICATION: six (6) inches diameter, minimum 24 MSG black or blued steel connector pipe,
with a listed factory-built UL103HT Class A chimney, suitable for use with solid fuels, or a masonry
chimney and the referenced clearances.
THIS ROOM HEATER MUST BE CONNECTED TO:
1) A chimney complying with the requirements for Type HT chimneys in the Standard for Chimneys,
Factory-Built, Residential Type and Building Heating Appliance, UL 103, or
2) A code-approved masonry chimney with a flue liner.
INITIAL ADVICES
•
The stove must be installed on a floor with adequate capacity. If the existing building
does not meet this requirement, appropriate measures (eg, load distribution plate)
must be taken.
•
The installation must guarantee easy access to clean the stove, the smoke pipes and
the chimney flue as well.
•
Air extraction fans, when installed in the same space or room with the stove can
cause draft problems
•
ALL LOCAL REGULATIONS MUST BE RESPECTED IN THE INSTALLATION OF THE
STOVE.
•
Do not use the stove as an incinerator or in any other way different from the one it
has been conceived for.
•
Do not use fuels different from those recommended.
•
Do not use liquid fuels.
•
NEVER USE GASOLINE, GASOLINE-TYPE LANTERN FUEL, KEROSENE, CHARCOAL
LIGHTER FLUID, OR SIMILAR LIQUIDS TO START OR “FRESHEN UP” A FIRE IN THIS
HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY FROM THE HEATER WHILE IT IS IN
USE.
•
The stove, especially the external surfaces, while it is working gets hot to the touch.
Handle carefully to avoid burns.
•
Do not perform any unauthorized modification to the stove.
•
Use only original replacement parts recommended by the Manufacturer.