14221-1800-2050, Rev. G
123
B.5 PUT THE RADIO IN WI-FI PROGRAMMING MODE
To put the radio in Wi-Fi programming mode:
1. Turn the radio off and remove the USB cable (optional).
2. Press and
hold the bottom portion of the PTT switch and either of the two side YELLOW buttons on
power-up to enter WIFI Programming mode
.
3. Release the buttons when the
WIFI INSTALL ACTIVE
screen appears on the radio.
4. Initially, the radio displays
DISCONNECTED
. When the IP address is displayed, the radio is
available to be programmed.
Figure 12-5: Enable Wi-Fi Programming Mode on Radio
Refer to Section 5.37.2 for Wi-Fi Client selection information.
NOTE