L3Harris NARDA PMM ER8000, Руководство пользователя

Страница: 19 / 82

Installation 2-1
2 - Installation
2.1 Introduction This section provides the information needed to install your PMM ER8000.
It includes the information pertinent to initial inspection and power
requirements, connections, operating environment, instrument mounting,
cleaning, storage and shipment.
2.2 Initial Inspection
2.3 Packing and
Unpacking
When receiving the equipment, first inspect the shipping cardbox for any
damages.
If the shipping box is damaged, it should be kept until the contents of the
shipment have been checked for completeness and the instrument has
been checked mechanically and electrically.
Verify the availability of all the shipped items with reference to the shipping
check list enclosed with the Operating Manual.
Notify any damage to the forwarder personnel as well as to your NARDA
Representative.
To avoid further damage, do not turn on the instrument when there
are signs of shipping damage to any portion of it.
2.4 Preparation for Use
This is a Safety Class I apparatus, but it is also equipped with a
protective/functional earth terminal on the rear panel. A good
safety/functional ground connection should be provided before to
operate the receiver.
2.5 AC/DC Power Supply
The power supply supplied with the receiver can work at either 50 Hz or 60
Hz with a supply voltage rated between 100 and 240 Volt.
It is supplied with different connectors to fit all the possible outlets in
accordance with the various National standards.
+
-
Battery charger: DC, 10 - 15 V, ~ 2500 mA
=> DC Connector
2.5.1 To replace the
mains connector of
AC/DC Power Supply
To replace the mains connector, simply remove the one installed on the
Power supply sliding it off, and insert the one that fits the outlets in use.
Document ER8000EN-01101-1.00 - © NARDA 2020