L.T. Rich Products Z-Spray, Руководство пользователя

Страница: 34 / 36

DC Output Charging Wire Test
A simple test can be used to test the DC output charging wire circuit. If a wiring problem
exists it can be corrected before testing regulator-rectifier.
Leave stator wire harness disconnected from regulator-rectifier. Equipment key switch
must be in
OFF position.
1. Insert RED test lead into VΩ receptacle in meter.
2. Insert BLACK test lead into COM receptacle.
3. Rotate selector to V= = (DC volts) position.
4. Attach RED test lead probe (2) to the RED wire (5) DC output terminal (7), of the
connector. (Figure 31).
5. Attach BLACK test lead probe (1) to negative battery terminal.
6. Turn equipment key switch to ON position. Meter should display
BATTERY
VOLTAGE.
7. If meter does not display voltage, check for blown fuse or broken or shorted wire.
Regulator-Rectifier Test
Tools Required:
DC Shunt #19359
The DC Shunt MUST be installed on the NEGATIVE (-) terminal of the battery, Figure
32 to avoid blowing the fuse in the meter when testing the output of the 20 amp system.
All connections must be clean and tight for correct readings.
1.
Connect stator wire harness to regulator-rectifier.
2. Install DC Shunt #19359 (4) on NEGATIVE battery terminal.
3.
Insert RED test lead into VΩ receptacle in meter and connect to RED post terminal
on shunt (5), Figure 32.
4. Insert BLACK test lead in COM receptacle in meter. Connect to BLACK post
terminal on shunt (3).
5. Rotate selector to 300mV position.
6. With the engine running at 3600RPM , the output should be 3-20 Amps .
NOTE: Depending on battery voltage and/or current draw on system
If NO or LOW output is found, be sure that regulator-rectifier is grounded properly and
all equipment connections are clean and secure. If there is still NO or LOW output,
replace the regulator-rectifier.
Page 30