REV5
For any questions please contact us at toll free (877) 482-2040 Mon-Fri 8 a.m. to 4:30 p.m. 24
135lb Stainless Steel Spreader Installation
5.3
SPREAD PATTERN SET-UP
This section contains instructions on how to set up a spread pattern with the 135lb. Stainless
Steel Spreader. Note that other conditions such as weather, operator driving speed, etc. can
affect the spread pattern. Adjust accordingly. See Figure 8.
1.
Make sure Spinner Switch is in the OFF position and the Snowrator is OFF.
2.
Check the Hopper to verify it is clean and free of product. If not, clean it with
compressed air.
3.
Check Hopper sliding door guides for damage.
4.
Set Rate Control using the nut & bolt on the front of the machine and verify Hopper Door
opening width.
5.
Adjust the Directional Control to the desired direction and opening width.
6.
Fill the Hopper with the desired product.
7.
Turn on Spinner. Only use Vibrator if material is not flowing.
8.
Set the Spinner speed.
9.
Open Hopper Door and observe spread pattern.
10.
Turn off Vibrator and Spinner and adjust settings if necessary.
Aux Control Panel
Speed Control
(See Figure 2)
Rate Control
Directional Control
Control
