STEP 6
Attach the leg assembly from STEP 5 to
the top assembly (A) by inserting a
carriage bolt through the predrilled holes
in the leg supports on the underside of the
tabletop and through the leg assembly.
Add a washer and fasten with a locknut.
Repeat to other leg assembly.
Note: Use 2 ¾” carriage bolt for (B) leg
and use 2” carriage bolt for (C) leg.
Take care in aligning the legs on the
inward side of the leg support brackets,
which were factory mounted to allow for
the offset of the legs.
STEP 7
Connect the leg assemblies using leg
stretchers (D). Insert the 1 ½” screws
through the two small predrilled holes at
the base of each leg inward into the pilot
holes in the ends of each leg stretcher.
Note: You may now tighten the carriage
bolts fully and then tighten the machine
screws connecting the legs.
