13
16 = control via button 8
64 = control via lighting button
(On only when reversing)
65 = control via button 1
(On only when reversing)
128 = control via lighting button
(On only when moving forward)
129 = control via button 1
(On only when moving forward)
CV52
Command for front light terminal
[128]
(see CV 51)
CV53
command for rear light terminal
[64]
(see CV51)
CV54
Hand-off function and “Back-EMF”
(0..3)
[2]
0 = hand-off function off, Back-EMF off
1 = hand-off function on, Back-EMF off
2 = hand-off function off, Back-EMF on
3 = hand-off function on, Back-EMF on
Hand-off function on: When operating with
55015, you can adjust direction and speed for
two seconds after selecting a moving loco
without causing the loco to stop.
CV55
Reset of most programmed CVs
55 = most important CVs are reset to the
factory pre-set values
CV60
Back-EMF: Max. adjustment factor
(1..255)
[48]
(0: small, 255: large)
Specifies the max. increase or decrease of
voltage applied during each time interval
(programmed in CV61)
Attention!
The factory pre-set values of CV60
and CV61 are optimized for LGB motors.
CV61
Back-EMF: Adjustment frequency
(0..255)
[0]
(0: often, 255: seldom)
Specifies how often per second the motor
voltage is adjusted - accordingly, the loco will
react to curves and grades immediately or with
a short delay
CV62
Back-EMF: Max. Adjustment (0: small, 255: max.) (0..255)
[255]
Limits the total adjustment in motor voltage.
If there is a very large load on the motor, the
adjustment will not exceed this value - for more
realistic operations, so that locos will slow
a bit on grades.
CV67
Speed steps programmed by user (see CV29):
(0..255)
to
28 speed steps are programmed in CV67 to
CV94.
CV94
With LGB MTS, every second value is skipped
(14 speed steps).
Factory pre-set speed steps:
7, 9, 11, 13, 16, 20, 24, 28, 32, 36, 42, 48, 54,
60, 68, 76, 84, 92, 102, 112, 124, 136, 152,
168, 188, 208, 230, 255
Pre-set values for user-programmable
speed steps:
8, 16, 24, 32, 40, 48, 56, 64, 72, 80, 88, 96,
104, 112, 120, 128, 136, 144, 152, 160, 168,
176, 184, 192, 208, 224, 240, 255
Hint:
The speed steps are factory pre-set and
programming is not necessary. Use the
55045 MTS PC Decoder Programming
Module for programming.
