
32
© DiskArt™ 1988
Green, constant
: normal operation
Red, slow flashing
(4 on, 4 off): Emergency stop button has been pressed.
To restart operation, wait a few seconds, then press the "Stop" button on
your remote once. Or press the Reset button on the Central Station.
Or short circuit
. In this case, remove the cause of the short circuit. Then
press the emergency stop button on your MTS throttle or the Reset button
on the Central Station to resume operation. After multiple short circuits
(overheating), the Central Station will be blocked for approximately
1.5 minutes. During this time, the Reset button is blocked as well.
Red, constant
: Central Station is overheating. Wait until the Central Station
has cooled off. Improve air flow to the Central Station. Keep the air vents
of the Central Station clear. After the Central Station has cooled off, the
LED flashes red. Press the emergency stop button on your MTS throttle
and resume operation with fewer locomotives.
Red, rapid flashing
(1 on, 1 off): Error at MTS Power Extender. Short circuit
in track section connected to the MTS Power Extender. Remove the cause
of the short circuit, etc. (see above).
Red, 2x asynchronous flashing
(1 on, 1 off, 1 on, 5 off): MTS II Bus
overload. Check input devices for defective wires. Remove the defective
input device. Press the Reset button on the Central Station and resume
operation.
Grün, Dauerleuchten
: normaler Fahrbetrieb
Rot, langsam blinkend
(4 an, 4 aus): Nothalt-Taste wurde
gedrückt. Zum Wiedereinschalten der Anlage nach einer Pause
Nothalt-Taste ("Stop") am Handy einmal drücken. Oder "Reset"-
Taste an der Zentrale drücken.
Oder
Kurzschluss
. In diesem Fall Kurzschluss entfernen und
Nothalt-Taste am Handy oder "Reset"-Taste an der Zentrale
drücken und den Betrieb wieder aufnehmen. Nach mehrmaligen
Kurzschlüssen (Übertemperatur) ist die Zentrale ca. 1,5 Minuten
lang gesperrt, die "Reset"-Taste funktioniert dann nicht.
Rot, Dauerleuchten
: Überhitzung der Zentrale. Zentrale abkühlen
lassen. Zentrale besser belüften. Luftschlitze der Zentrale frei-
halten. Nach Abkühlen geht die Zentrale in den Nothalt-Modus.
"Reset"-Taste der Zentrale drücken. Betrieb mit weniger Loko-
motiven wieder aufnehmen.
Rot, schnell blinkend
(1 an, 1 aus): Fehlermeldung vom MZS-
Power-Booster. Kurzschluss im Booster-Bereich. Kurzschluss
beheben, usw. (s. oben).
Rot, 2x kurzes asynchrones Blinken
(1 an, 1 aus, 1 an, 5 aus):
MZS II-Bus überlastet. Eingabegeräte auf defekte Kabel über-
prüfen. Defektes Eingabegerät entfernen. "Reset"-Taste an der
Zentrale drücken und Betrieb wieder aufnehmen.
70255_Starter_22_37.qxd 19.04.2006 12:19 Uhr Seite 12