Calefactores canalizados Premier
Manual del usuario • Premier 350
21
Límite del extremo del motor:
Protege contra el
recalentamiento si el conducto está retorcido u obstruido, o
si la entrada de aire está bloqueada.
Los interruptores están conectados en serie y desconectan
la energía a la válvula de control de gas si cualquiera de
ellos detecta una condición de recalentamiento.
Ambos interruptores de límite superior se deben probar
como mínimo una vez al año cuando se realiza la limpieza
profunda del calefactor.
1. Extraiga los interruptores de limite alto del calefactor.
Extraiga también la tapa roja de ambos interruptores.
2. Sosteniendo un interruptor por una de sus patas de
montaje, aplique una llama pequeña solamente a la zona
de detección de la parte posterior del interruptor. Vea la
Fig. 28. Actúe con precaución para no derretir el recinto
de plástico del interruptor durante esta prueba.
FIG. 28
3. En un plazo de un minuto, debería oír que los contactos
del interruptor se han abierto.
4. Deje que el interruptor se enfríe durante
aproximadamente 1 minuto antes de presionar con
¿UPH]DVXERWyQGHUHVWDEOHFLPLHQWR9XHOYDDFRORFDUOD
tapa roja en el interruptor.
5. Compruebe la continuidad eléctrica en los terminales del
interruptor para asegurarse de que se hayan cerrado los
contactos.
Turbina, rodamientos y eje
1. Quite lo siguiente.
a. Protector de la correa y correa.
b. Pernos y arandelas que aseguran la plataforma del
rodamiento en la base del calefactor.
c. Tornillos que aseguran el panel del ventilador al recinto
del ventilador.
2. Deslice el conjunto completo para extraerlo del
calefactor.
Boton de
restebleci-
miento
Terminal
6XSHUÀFLHGH
deteccion
Llama
Pata de montaje
3. Reemplace los componentes según sea necesario.
4. Cuando los reinstale, asegúrese de que el eje del
ventilador quede a tope con el cubo del ventilador. Vea la
Fig. 29.
FIG. 29
Orificio del quemador y
válvula de control de gas
1. Extraiga la manguera y el niple del tubo de la entrada de la
válvula de control.
2. Abra la puerta del extremo del quemador.
3. Extraiga los tornillos del bastidor del control de gas y
desconecte el cableado eléctrico de la válvula de control.
Vea la Fig. 30.
FIG. 30
Eje plano
Eje al ras con el
cubo de la polea
Cubo de polea
Soporte principal
La pista del rodamiento está al ras con el borde
delantero del eje plano. Fije los tornillos apreta-
dos completamente.
Cubo del ventilador
al ras con el extremo
del eje
Rueda de
ventilador
Tornillos