![background image](http://html1.mh-extra.com/html/l-b-white/sun-blast-hd-cr100/sun-blast-hd-cr100_owners-manual-and-instructions_3233693007.webp)
Sun Blast HD
Owner’s Manual • Sun Blast HD
7
safe and normal operating condition. You must
completely familiarize yourself with each model
heater by reading and complying with the safety
instructions, labels, Owner’s Manual, etc., that is
provided with each heater.
b. To be a qualified gas installation person, you must
have sufficient training and experience to handle
all aspects of installing, repairing and altering gas
lines, including selecting and installing the proper
equipment, and selecting proper pipe and tank size
to be used. This must be done in accordance with
all local, state and national codes as well as the
manufacturer’s requirements.
c. In the Commonwealth of Massachusetts, these
products must be installed by a gas fitter licensed
by the Commonwealth of Massachusetts.
2. All installations and applications of L.B. White
heaters must meet all relevant local, state and
national codes. Included are L.P. gas, natural gas,
electrical, and safety codes. Your local fuel gas
supplier, a local licensed electrician, the local fire
department or similar government agencies, or
your insurance agent can help you determine code
requirements.
In the absence of local codes, refer to:
-- ANSI/NFPA 58, latest edition, Standard for Storage
and Handling of Liquefied Petroleum Gas
-- ANSI Z223.1/NFPA 54, National Fuel Gas Code
-- CSA B149.1, Natural Gas and Propane Installation
Code.
3. Not for use with duct work.
4. We cannot anticipate every use which may be
made of our heater. Check with your local fire
safety authority if you have questions about
applications.
5. Other standards govern the use of fuel gases and
heat producing products in specific applications.
Your local authority can advise you about these.
6. Use only compressed air, soft brush or dry cloth to
clean the interior of the heater and it’s components.
7. Always use approved pipe thread compound
suitable for use with propane gas on the threaded
connections.
• Propane gas has a distinctive odor. Learn to
recognize this odor. (Reference “Fuel Gas Odor”
and “Odor Fading” section above.
• If you have not been properly trained in repair and
service of propane gas fueled heaters, then do not
attempt to light heater, perform service or repairs,
or make any adjustments to the heater on propane
gas fuel system.
• Even if you are not properly trained in the service
and repair of the heater, ALWAYS be consciously
aware of the odor of propane gas and natural gas.
• A periodic sniff test around the heater or at the
heater’s joints; i.e. hose, connections, etc., is a good
safety practice under any conditions. If you smell
even a small amount of gas, CONTACT YOUR
FUEL GAS SUPPLIER IMMEDIATELY.
DO NOT WAIT!
1. Do not attempt to install, repair, or service this
heater or the gas supply line unless you have
continuing expert training and knowledge of gas
heaters.
Qualifications for service and installation of this
equipment are as follows:
a. To be a qualified gas heater service person, you
must have sufficient training and experience to
handle all aspects of gas-fired heater installation,
service and repair. This includes the task of
installation, troubleshooting, replacement of
defective parts and testing of the heater. You
must be able to place the heater into a continuing
Attention - Critical
Points to Remember!
WARNING
Burn Hazard
■ High surface and discharge temperatures.
■ Do not touch the heater or come within safe
clearances given on dataplate or owner’s
manual.
■ Use extreme caution when lighting the heater
or adjusting heat levels.
■ Failure to follow this warning can result in
burns or ignition of clothing.
■ Burns cause serious injury or death.