![background image](http://html2.mh-extra.com/html/l-b-white/premier-ts080/premier-ts080_owners-manual_3100413014.webp)
13
■
Only use the L.B. White regulator supplied with the
heater.
■
The heater must be regulated at all times for proper
operation.
■
The regulator must be installed so its vent are directed
downward.
■
Leak check all regulator connections whenever the
regulator is connected to the gas supply.
Propane Gas Heaters
1. Remove the cap from the POL fitting. Insert the POL
stem into the cylinder valve. Push the spring loaded
hand wheel up against the threaded nut. Turning
counter clockwise, thread the POL nut into into the
container valve using the hand wheel. Firmly tighten.
See Fig. 13.
FIG. 13
2. Slowly open the cylinder valve. This will prevent lock-
up of the excess flow valve built within POL stem.
3. When storing or transporting the heater, ensure the
POL fitting is protected from damage and water entry.
Natural Gas Heaters
---
A regulator is required if the supply pressure to the
heater is above the maximum pressure stated on the
heater’s dataplate.
---
Connect the natural gas regulator (part # 09795) to
the natural gas supply line. Gas supply pressure to
the regulator must be a minimum of 14 in.W.C./3.48
kPa.
CONNECTING REGULATOR TO GAS SUPPLY
HAND WHEEL
TS170G-07
CAGE NUT
SLOT
WING SCREW
INSERT TAB AT BOTTOM OF COLLAR
INTO SLOT BEFORE TIGHTENING
WING SCREWS INTO CAGE NUTS.
1. Wrap the duct clamp around duct and collar. Saddle
of clamp lays over duct coil. Connect clamp ends
together and tighten securely. See Fig. 11.
FIG. 11
2. Position the diffuser under the tent wall as shown.
Lay the tent material within the channel of the
diffuser. Ensure the material is securely anchored
within the channel. See Fig. 12.
FIG. 12
END DIFFUSER
Accessory 26350
DUCT EXTENDED
TO FULL LENGTH
TENT SIDE WALL
MATERIAL LOCATED IN
CHANNEL AND ANCHORED
SECURELY
AIR DIFFUSER
Содержание Premier TS080
Страница 2: ......