![background image](http://html1.mh-extra.com/html/l-b-white/aw060/aw060_installation-and-service-manual_3182684063.webp)
Servicing
Instructions
8.6-1
1
Procedure
:
1. Shut off the gas supply to the heater and disconnect
the heater from its power supply.
2. Open the burner end access panel.
3. Regardless of burner design, disconnect male and
female connectors located at the end of igniter leads
and loosen the screw securing the igniter shield (if
applicable) and igniter to mounting bracket.
4. Remove the igniter and the igniter shield (if
applicable) from its mounting bracket.
5. Connect the replacement igniter to its power supply
wiring.
6. Slide the igniter and igniter shield down over the
mounting screw so the mounting slots of these
components straddle the screw.
7. Tighten the screw snugly. DO NOT OVERTIGHTEN.
Overtightening can cause cracks in base of igniter,
possibly leading to future igniter failure.
August 1999
Connectors
Igniter
Shield
Heaters w
with C
Cast B
Burner
Heater w
with B
Burner PPlate
Burner pplate hhas iintegral
igniter sshield.
MAKE S
SURE TTHE IIGNITER AAND TTHE B
BURNER AARE C
COOL TTO TTOUCH B
BEFORE R
REPLACING IIGNITER.
Hot Surface Igniter Replacement