46
S
- Siphon hose - used to:
1. Winterize water system.
2. Sanitize water line system.
P -
Pump 12-volt
– To supply coach with
water when city water is not available.
F
– Filter Cap to be removed to clean out
or replace.
G -
Gravity water fill-To fill tank.
C
- City water fill-To fill lines.
T -
Tank
–To hold water.
V1
- Valve to be opened ONLY when
using siphon hose as listed above.
V2 -
Valve to be open to draw water from
supply tank, closed when siphon hose is
used.
12-volt Demand Pump
When water is desired and you are not hooked up to city water, your tank
will be your supply. On your monitor panel is a switch to turn on the 12-
volt demand pump. Energy for the pump is supplied by the auxiliary
battery or converter. The pump will self-prime when started, supply
water, and continue to run until approximately 40 pounds of pressure is
achieved. When pressure drops to 20 pounds, pump will restart. Some
cycling in pump may occur. A check valve is built within the pump to
prevent water from flowing into the supply tank.
The pump has a small filter attached on the “in port” side to prevent any
foreign matter from entering the pump. You need to annually, or even
more often, remove the lower cup and clean it out or replace filter.
DO NOT leave tank unattended while filling, as an over filled
tank will build pressure, causing the tank to crack, rupture,
leak, or even damage supports holding it in place.
Excessive pressure from water supply systems may be
encountered in some parks, especially in mountainous
regions. Water pressure regulators are available to protect
your system against such high pressure. A regulator, rated at
45 pounds, is recommended to prevent damage to the
plumbing system or components.
Содержание Connect 2020
