Multi-Image Splicing Processor
5
3.2 Debugging Steps
Step 1:
Click “MENU” to enter into main menu interface and click “Device Mode” to select
splicing mode: copy mode, horizontal mosaic, vertical mosaic and cross mosaic.
Note: Copy mode: all output contents are consistent; horizontal mosaic: content of all output are arranged
horizontally; vertical mosaics: contend of all output are arranged vertically; cross mosaics: contend of all output
are arranged in two rows and two columns.
Step 2:
select suitable splicing mode and click “OK”; get back to main menu interface to
select “Screen parameter” and enter into its setting interface. Set loaded screen point of each
output interface and click “Confirm” after inputting, and then screen splice is finished.
Note: there are two ways for number input:
(1) Adjust by rotate knob. Step length can be adjusted by “×1”“×10”“×100”, for instance, “×100”means that
number of rotate knob increases by 100 each time.
(2) Input by number of the front panel. For example,
of the key refers to figure 1.
Device Mode
Copy Output
Horizontal Mosaic
Vertical Mosaic
Cross Mosaic
OUT
Note:
All output displays are
the same.
Confirm
Cancel
×
1
×
10
×
100
OUT1
OUT2
OUT3
OUT4
Screen Parameters
Horizontal Size: 1920
Vertical Size:1080
Rotate knob to select output
Click “OK” to adjust
Select by Finger key
S1
