Kyocera TJEP ST-15/50 GAS, Инструкции по безопасности и эксплуатации

Страница: 68 / 72

66
• Tap the screw driver with a hammer to push back
the driver blade and release the jam.
• Remove the jammed fastener with needle-nose
pliers or similar type of tool. Do not use your hand
to remove the fastener.
• If you failed to remove the jammed fastener by
above method contact your local TJEP dealer.
Jam clearing for finish nailers
• In the case of fastener jam, disconnect the fuel cell
and battery before you perform any actions.
• Release pusher to avoid pressure on the fastener
strip.
• Open the driver guide cover by releasing the latch.
• For TJEP ST-15/50 GAS; remove the 2 screws in
the nose piece.
• Remove the jammed fastener with needle-nose
pliers or similar type of tool. Do not use your hand
to remove the fastener.
• Secure the driver guide cover after you clear the
jam.
• For TJEP ST-15/50 GAS; reassemble the nose
piece.
Jam clearing for concrete nailers
• In the case of fastener jam, disconnect the fuel cell
and battery before you perform any actions.
• Release pusher to avoid pressure on the fastener
strip.
• Remove magazine by releasing the magazine
lock.
• Remove nozzle, clear jam and reassemble the
tool.
Charging the battery and LED
explanation
• There are 2 batteries supplied with the gas tool. It
will take 1 ½ hours before the new battery is fully
charged.
• There will be green LED lightening when the bat-
tery charger is connected to electric power and no
battery is on the battery charger.
• The LED indicator on the battery charger will turn
red when it is charging a battery.
• The other LED indicator will turn green when the
battery is fully charged.
• When the gas tool is connected to a charged bat-
tery, the LED indicator on the tool will turn green.
State of Battery Charger LED Indicator
State Red LED Green LED
1
Battery installed
and charging
ON OFF
2
Battery at full
charge
OFF ON
3 Defect battery Blinking Blinking
LED Indicator on tool
State Red LED Green LED
1
Charged battery
in tool
ON OFF
2
Battery needs
to be charged/
replaced
OFF ON
Maintenance instructions
General maintenance
• Clean the intake filter regularly to keep the tool in
full efficiency.