Kyocera KR1 - Mobile Router Wireless, Быстрое руководство по установке

Страница: 7 / 36

3
Installation Instructions
Connect the Kyocera KR1 Wireless Router to Your Network
Note:
Ensure that power to your Kyocera KR1 Mobile Router is not connected before performing the
installation steps below.
32-bit PCMCIA (EVDO) Card or 1xEV-DO Mobile Phone Connection
Note:
To preserve the life of your phone’s battery, it is recommended that you use your phone’s charging
cradle when connected to the Kyocera KR1 Mobile Router.
1.
Attach the antenna.
a. Remove the antenna from its plastic wrapper.
b. Screw the antenna in a clockwise direction to the back panel of the unit .
c. Once secured, position the antenna upward at its connecting joint. This will ensure optimal reception
(see
“Figure 1: Connections– Kyocera KR1 Mobile Router (Back View)” on page 2 ).
2.
Connect a compatible 32-bit PCMCIA (EVDO) card with service , or 1xEV-DO mobile phone with service ,
to your Kyocera KR1 Mobile Router in one of the following ways:
• Insert your wireless 32-bit PCMCIA (EVDO) card into the WAN (EVDO) 32-bit PCMCIA Card Slot, or
• Connect your wireless 1xEV-DO mobile phone to the “Phone In” jack, with your USB phone cable.
Note:
The Kyocera KR1 Mobile Router is designed to work with EVDO-capable handsets that can be used
as a modem (support tethered data). Please refer to your service provider for detailed feature
information. Support is also available at http://www.kyocera-wireless.com/support.
3.
Insert the Ethernet patch cable into LAN Port 1 on the back panel of the Kyocera KR1 Mobile Router, and
an available Ethernet port on the network adapter in the computer you will use to configure the unit.
Note:
The Kyocera KR1 Mobile Router LAN Ports are “Auto-MDI/MDIX.” This provides either patch or
crossover Ethernet cable LAN Port access.
4.
Connect the power adapter to the receptor on the back panel of your Kyocera KR1 Mobile Router.
Then plug the other end of the power adapter into a wall outlet or power strip.
• The Power LED will turn ON to indicate power has been applied.
• Other LEDs will flash ON and OFF as the Kyocera KR1 Mobile Router performs initialization and Internet
connection processes. This will take a few minutes.
• When complete, the following LEDs will illuminate green: Power, Status, WAN, WLAN, and LAN Port 1
(or your specific LAN Port connection).
Note:
If you have connected a 1xEV-DO mobile phone to your Kyocera KR1 Mobile Router, the Phone LED
will also illuminate green.
Using the Setup Wizard
Note:
Once properly configured, your Kyocera KR1 Mobile Router will obtain and assign IP address
information automatically.
Perform the following steps to access the
Run Wizard
web-management interface of the
Kyocera KR1 Mobile Router
.
1.
Open your Web browser and type
http://192.168.0.1
in the URL address box. Press
Enter
.
82-N8462-1SF.book Page 3 Friday, November 11, 2005 2:32 PM