Kyocera FS-1110, Руководство по эксплуатации

Страница: 54 / 88

4-2 Maintenance
General Information
This chapter describes basic maintenance tasks you can perform for the
printer. You can replace the toner container according to the printer's
status:
Also, the internal parts need periodic cleaning.
Toner Container Replacement
The Toner indicator identifies the toner status at two stages of toner
usage.
• When the printer becomes low on toner, the Toner indicator flashes.
Note the replacement is not always necessary at this stage.
• If you ignore the above status and continue printing, the Toner
indicator lights up just before the toner is used up. The toner
container must then be replaced immediately.
In either case, replace the toner container.
Frequency of toner container replacement
According to ISO/IEC 19798 and EcoPrint switched off the toner
container can print as follows A4/Letter paper is assumed): 2,100
pages.
You can print a status page to check how much toner remains in the
toner container. The Toner Gauge in the consumables status section on
the status page shows a progress bar, which roughly represents how
much toner is left in the toner container.
First Toner Container
The toner container packed with the new printer has to fill up the system
when operating the first time. Therefore only 50% of the first toner kit can
be used for printing. The toner container supplied with the printer will
print approximately: 1,000 pages.
Toner Kits
For best results, we recommend that you only use genuine Kyocera
Parts and Supplies. Should any damage be caused by the application of
a toner other than the original Kyocera Mita toner, then this damage is
excluded from the guarantee.
A new toner kit contains the following items:
• Toner Container
• Plastic waste bag for old toner container
• Installation Guide
Note Information Collection on Memory Chips - The memory chip
attached to the toner container is designed to improve
convenience for the end user; to support the recycling operation of
empty toner containers; and to gather information to support new
product planning and development. The information gathered is
anonymous - it cannot be associated to any specific individual and
the data is intended to be used anonymously.
Note Do not remove the toner container from the carton until you
are ready to install it in the printer.